RPM

RPM 80812 81562 81522 Front Rear Black Suspension A-Arms A arms Arrma KRATON 8s

$71.99

use code "chicago10" and save 10% off your order plus Free Shipping

RPM BLACK FRONT + REAR COMPLETE SET OF SUSPENSION ARMS

FOR KRATON 8S

(These replace Arrma arms)

PART#'s 80812 81562 81522

Rear A-Arms for the Arrma Kraton 8S

The ARRMA Kraton 8S is 26 lbs. (12kg.) of high-flying, dirt shredding, jump-killing fun! If your A-Arms aren't up to the abuse this massive monster can dish out, look no further than RPM. Our replacement rear A-arms are designed with the backyard basher in mind and can handle some serious

abuse and come back for more.

The rear A-arms have a triple beam style construction designed to spread impact energy across all three beams. Each beams cross-section is a whopping 5/8 (15.8mm) tall x 3/8 (9.5mm) wide. These massive beams reduce unwanted flex during normal suspension movement, yet allow impact-absorption during those not-so-perfect landings and crashes. We also moved the inner cross brace away from the chassis, eliminating the droop stop entirely. While this may seem counter-intuitive, our test truck's chassis was bent at the droop stops, clearly illustrating that extreme impacts were too much for the chassis plate to handle. After all, there's nothing worse than a bent chassis.

Tech Notes: RPM Rear A-arms for the ARRMA Kraton 8S are sold as a pair. RPM A-arms replace stock ARRMA #ARA330590.

RPM's front lower A-arms have a triple beam style construction designed to spread impact energy across all three beams. Each beam's cross-section is a whopping 5/8" (15.8mm) tall x 3/8" (9.5mm) wide. These massive beams reduce unwanted flex during normal suspension movement, yet allow impact-absorption during those not-so-perfect landings and crashes. They also moved the inner cross brace away from the chassis, eliminating the droop stop entirely. While this may seem counter-intuitive, the test truck's chassis was bent at the droop stops, clearly illustrating that extreme impacts were too much for the chassis plate to handle. After all, there's not much worse than a bent chassis.

RPM front upper A-arms use a dual beam construction where each beam is a massive 1/2" (12.7mm) tall x 3/8" (9.5mm) wide. RPM eliminated the tube shape over the hinge pin to eliminate built-in molding stresses, while beefing up the leading edge hinge pin support to add some much needed strength and durability.

Both upper and lower A-arms are molded with fingernail slots that allow easy access to remove the aluminum support ring (not included) at the pivot ball. Made in the USA from a trademark blend of ultra durable materials, you can't go wrong with RPM!

Installation Notes:: Like stock A-arms, RPM Kraton 8S versions are sold without threads. If the pivot ball hole is difficult to thread using the pivot ball, RPM recommends thread tapping (tap not included) the hole for 3-4 threads, but do not tap any further. Additional cut threads will negate the thread-locking capability of the materials.

BRAND NEW

YOU WILL RECEIVE A FULL VEHICLE SET AS SHOWN